| | Since 1996, an Unparalleled Know-how:The reason for the high performance of the RBS fanned Patches is the two dimensional "Isotropic" characteristic of their oriented Weaving.  | The combination of a minimal fiber quantity and optimal fiber orientation towards the corner permits the best strength to weight ratio. | | To Obtain the best cohesion, the Fanned Patches are laminated with continuous fiber coated and bonded together using Specific Flexible Adhesives, this with the minimum amount of glue possible. | | Only this method, with multi-directional weave ensures perfect stability of the reinforcement, better than any other reinforcement solution of the same weight or heavier. |
An Innovative Process for Sailmaking:This technique enables users to achieve light and efficient reinforced panels: | Consists of a piece ready to glue patch, the density of fibers in the reinforcement is varied according to the different zones of stress loading. | | Many sizes and combinations are available, with 9 standard formats to make reinforcements from 0.4 meters to 3 meters long. | | The user chooses the size of reinforcement required, and adjusts it in the following way:
- long side, zone of high density (for the leech)
- small side, zone of low density |
A Perfect Result: Lightness and efficiency:At sea, the result is totally flat without any tension under all conditions and angles | Lighter (Only one Ply in one piece ) | | Stronger (High Modulus Fiber Oriented and Bonded) | | Glued and Laminated onto sail (Very Durable and Flexible, no reinforcement movement) | | No Water Entrance, Very fast drying (close dry and wet weights) |
Industrial Manufacturing:Our process integrates a complex of systems and original solutions that we have improved over 6 years, in a 22 meter length machine, on 2 meter width manufacturing: |
| | | | |  View of the
texture phase | View of the
coating system
 | | | The automatic weaving is computer-controlled, which produces high regularity, both in tension and distribution. | |  View of the
Lamination phase | The Heat lamination of the triplex is performed on 2 meter wide units. | | | Process Control The complete process is controlled by Field buses and PC monitoring | 
| | |  Quality Control
in our laboratory | Environmental Saving Process: A gas burner is installed on our Owen to save energy and solvent exhaust.
Our global process limit also waste for cost and environmental saving. |
|
